- Deep groove ball bearings
- Cylindrical roller bearings
- Aligning ball bearings
- Stainless steel bearings
- LNSERTED bearings
- Ball introduced
- Plain Bearings
- Needle Roller Bearings
- Angular contact ball bearings
- Thrust Roller Bearings
- Spherical roller bearings
- Thrust Ball Bearings
- Rolling mill bearings
- Tapered Roller Bearings
- Plastic bearings
- Linear motion bearings
| How to install a cylindrical bore bearings TIMKEN | |||
| 点击数：4686 日期：2014/4/4 | |||
| TIMKEN separated type bearings are mounted in the inner ring and the outer ring can be conveniently arranged on the shaft or housing. This should arouse the attention of the is was already packed inner ring shaft is inserted into the outer ring of the bearing box has been installed, try to keep its concentric, to prevent scratches the rolling elements and raceways. With TIMKEN, the bearing inner ring and shaft at the outer bearing seat hole is non separable bearing loose fit for installation, Since the installation of separate type bearing inner ring and outer ring can be conveniently arranged on the shaft or housing. This should arouse the attention of the is was already packed inner ring shaft is inserted into the outer ring of the bearing box has been installed, try to keep its concentric, to prevent scratches the rolling elements and raceways. Coordination, on the import of TIMKEN bearing inner ring and shaft bearing seat hole at the outer ring is non separable bearing loose fit for installation, can press the bearing first installed in the shaft, and the shaft together with the bearing mounted to the bearing hole, if the bearing is small, also face a relatively soft metal hammer rings available the force bearing to, but the percussion force must be evenly distributed in the bearing ring. The seat hole of the bearing outer ring and bearing inner ring and shaft is tightly matched, is a loose fit, can be first in the shaft bearing. When the TIMKEN bearing ring and shaft or housing bore are tight fit, used to install a special set of drums and the bearing to the shaft or bearing seat When the TIMKEN bearing size is larger, because the installation force required for the larger, or bearing heavy load work interference larger so the cold installation difficulties, you need to advance to bearing inner ring or bearing seat heating after installation. In the hot state when installed, should strictly control the heating temperature. Heating of bearings, the heating temperature shall not exceed a maximum of 1200C, should be in commonly 80~1000C. The bearing can not be heated with shields or seals, otherwise it will cause the loss of lubricant. Heating can use electric induction with the wind, oil bath heating method. |
|||
| On a message：Japan Bearing Industrial Competitiveness latest market survey Next information：How to avoid bearing installation scars ? | |||